Характеристики
Canopy Access Point Module 5200AP/5700AP
Canopy AP - Точка Доступа используется как ретранслятор для доставки Интернет - сервисов к пользователям. Canopy AP может содержать антенну на 6 секторов, источник питания, GPS приемник, предназначенный для синхронизации точек доступа и радио-мостов, Ethernet коммутатор с возможностью подачи питания по незадейственным парам кабеля «витая пара». На одной точке доступа АР могут быть зарегистрированы 200 модулей абонента. Одна точка доступа может адресовать 4096 MAC / Ethernet адресов.
| Operating Frequency Range U-NII Mid band |
5.25 to 5.35 GHz and 5.725 to 5.825 GHz |
| Access Method |
TDD/TDMA |
| Signaling Rate |
10 Mbps |
| Modulation Type |
High Index BFSK (Optimized for interference rejection) |
| Carrier to Interference (C/I) |
3dB 10-4 BER @ -65 dBm |
| Receiver Sensitivity |
-83dBm 10-4 BER |
| Operating Range |
Up to 2 miles with integrated antenna in the 5.2 GHz band. Up to 10 miles with passive reflector in the 5.7 GHz band. |
| Transmitter Power |
Meets FCC UNII ERP Limit |
| DC Power |
24 VDC @ 0.3 Amp (active state) |
| Interface |
10/100 BaseT, half/full duplex Rate auto negotiated (802.3 compliant) |
| Protocols Used by CANOPY |
IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP |
Software
Upgrade Path |
Remotely downloaded into
FLASH via RF link |
Network
Management |
HTTP, TELNET, FTP, SNMP |
| Wind |
190 km/hr (118 miles/hr) |
| Operating Temperature |
-30ЕC to +55ЕC (-40ЕF - +131ЕF) |
| Weight |
1 lb. (.45kg) |
| Dimensions |
11.75" H x 3.4" W x 3.4" D (29.9 cm H x 8.6 cm W x 8.6 cm D) |
Canopy Cluster Management Module 1008CK
Модуль управления кластером обеспечивает коммутацию эллементов кластера, их питание от сети переменного тока, и синхронизацию точек доступа АР в кластере.
| Max length any one adio can be from Cluster Management Module |
100 Meters |
| Dimensions |
11.75” H x 15.0” W x 6.25” D (29.9 cm H x 38.1 cm W x 41.3 cm D) |
| Weight |
19.0 lbs. (8.6 kg) |
| Operating Temperature |
-30ЕC - +55ЕC (-40ЕF - +131ЕF) |
| AC input voltage |
90 VAC to 260 VAC |
| AC frequency |
47 to 63 Hz |
| AC input power |
75 W Typical with 8 radios, 90 W max at 120 VRMS |
| AC inrush current |
25A at 115 VAC
50A at 240 VAC |
| current (cold start –40C) |
50A at 240 VAC |
| EMI emissions |
FCC part 15, class A |
24 VDC Power Supply
| 24 VDC @ 12A |
Radios 100 Meters maximum from Cluster Management Module |
12 VDC Power Supply
| Radios 20 feet maximum from Cluster Management Module (8 radios), Power supply can be 10 feet from Cluster Management Module with Min. 12 gauge copper wire. |
5.68A typical |
Grounding
| Cluster Management Module |
Must use 10 gauge copper wire to attach one end to the chassis plate in the Cluster Management and the other end to earth ground, per National Electrical Code (NEC). |
Cable Specifications
| Ethernet, GPS sync, and GPS coax cables |
The use of cables that conform to the operational temperature of
the product as well as being UV
light protected is mandatory |
GPS
| “Keep Alive” battery power |
Upon power up, Cluster Management needs 5-minutes to recover GPS timing pulse. It is strongly recommended to have an uninterrupted power supply (UPS) back up on the Cluster Management Module power system. |
Ethernet Switch
| Switch type |
Unmanaged, store & forward |
| Ethernet protocols supported |
All standard IEEE 802.3 |
| Full or half duplex operation |
Auto-sensing |
Canopy Subscriber Module 5200SM/5700SM
Каждый Canopy SM может работать с одной Точкой Доступа (AP) в данный момент времени. Синхронизация и управления осуществляется по радиоканалу с Точки Доступа. Canopy SM устанавливается вне помещения и позиционируется по линии прямой видимости с точкой доступа. Модуль подключается к абонентскому оборудованию через кабель типа «витая пара категории - 5», предназначенной для использования вне помещения и имеющего защиту от ультрафиолетового излучения. Подключение Canopy SM к абонентскому оборудованию (персональному компьютеру или серверу)
| Operating Frequency Range U-NII Mid band |
5.25 to 5.35 GHz and 5.725 to 5.825 GHz |
| Access Method |
TDD/TDMA |
| Signaling Rate |
10 Mbps |
| Modulation Type |
High Index BFSK (Optimized for interference rejection) |
| Carrier to Interference (C/I) - also known as Jitter |
3dB, 10-4 BER @ -65 dBm |
| Receiver Sensitivity |
-83dBm 10-4 BER |
| Operating Range (all weather) |
Up to 2 miles with integrated antenna in the 5.2 GHz band. Up to 10 mile with passive reflector in the 5.7 GHz band. |
| Transmitter Power |
Meets FCC UNII ERP Limit |
| DC Power |
24 VDC @ 0.3 Amp (active state) |
| Interface |
10/100 BaseT, half/full duplex Rate auto negotiated (802.3 compliant) |
| Protocols Used by Canopy |
IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP |
| Protocols Supported by Canopy |
Switched Layer 2 Transport with support for all common Ethernet protocols including IPV6, NetBIOS, DHCP, IPX, etc. |
| Software Upgrade Path |
Remotely downloaded into FLASH via RF link |
| Network Management |
HTTP, TELNET, FTP, SNMP |
| Wind |
190 km/hr (118 miles/hr) |
Operating
Temperature |
-30ЕC - +55ЕC (-40ЕF - +131ЕF) |
| Dimensions |
11.75” H x 3.4” W x 3.4” D (29.9 cm H x 8.6 cm W x 8.6 cm D) |
| Weight |
1 lb. (.45kg) |
Canopy Backhaul Module 5700BH
BH модуль /основной – master режим/ – используется для организации канала связи точка-точка, например для того чтобы обеспечить подключение к пакетной сети удаленный кластер / группу радиоголовок. BH модули используют узконаправленную антенну. В каждом пролете радимоста один из BH модулей конфигурируется как основной / master (5700BHMRF). Основной / master BH передает синхронизацию ведомому модулю / slave (5700BHSRF). BH подключается таким же способом к кластеру как и обычная точка доступа.
Operating Range
(all weather) |
Up to 2 miles with integrated antenna. Up to 20 miles with installed passive reflectors. |
| Transmitter Power |
Meets FCC UNII ERP Limit |
| DC Power |
24 VDC @ 0.3 Amp (active state) |
| Interface |
10/100 BaseT, half/full duplex Rate auto negotiated (802.3 compliant) |
Protocols Used
by Canopy |
IPV4, UDP, TCP, ICMP, Telnet, HTTP, FTP, SNMP |
Protocols
Supported by
Canopy |
Switched Layer 2 Transport with support for all common Ethernet protocols including IPV6, NetBIOS, DHCP, IPX, etc. |
Software
Upgrade Path |
Remotely downloaded into
FLASH via RF link |
Network
Management |
HTTP, TELNET, FTP, SNMP |
| Wind |
190 km/hr (118 miles/hr) |
Operating
Temperature |
-30ЕC - +55ЕC (-40ЕF -
+131ЕF) |
| Dimensions |
11.75” H x 3.4” W x 3.4” D
(29.9 cm H x 8.6 cm W x 8.6 cm D) |
Weight
With Passive Reflector |
1 lb. (.45kg)
6.5 lbs. (3 kg) |
Canopy Surge Suppressor 300SS
| Dimensions |
H 5.2” x W 5.0” x D1.7” H 132 mm x W 127 mm x D 43.2 mm |
Space between
mounting holes |
4.25” (108 mm) |
| Size of Knockouts |
0.75” (19 mm) |
| Weight |
0.4 lbs. (180 g) |
| Operating Temperature |
-30ЕC to +55ЕC (-40ЕF to 131ЕF) |
| Internal Connectors |
RJ45 |
| Capacity |
1500J peak pulse energy dissipation with 10/10000µs waveform |
|
Схема проезда 
info@radios.ru 
